Free songs

Corners

Angles

Angles – Self-adhesive Buckling Angles – Finishing Angles

Self-adhesive buckling angles are supplied on rolls of 50 m and cut to length.
Easy and comfortable use by inner and outer angles for connection to the wall.
Double buckling power of angles.
”Waste free” application.
SKS standard – standard for exterior and interior mounting.
Accessories: special scissors for a clean cut.

Self-adhesive buckling angles are available in the following range:

- WKL1515 – 15×15 mm,
- WKL2525 – 25×25 mm,
- WKL2040 – 20×40 mm,
- WKL3030 – 30×30 mm,
- WKL3535 – 35×35 mm,
- WKL4040 – 40×40 mm.

On rolls of 50 m.
With two or one tapes or without tape.
Tape liners are blue or green on request.

Minimum order: 50 m.
Shipment time: generally on stock/ 2 weeks.
Shipment conditions: EXW Ogre, Latvia.

All our profiles are produced from high-quality German PVC-granulate and with German self-adhesive foam tape.
Our tape has increased adhesive features up to -10 C.
SKS standard – standard for exterior and interior mounting.
Adhesive: acrylate glue.
Adhesive application: 120 g/m2.
Temperature range: -40˚C to +120˚C.
Adhesive properties: aggressive adhesive.
We exclusively order this tape especially for Nordic countries.
Material – white hard PVC.
UV-resistance due to high content of TiO2 (titanium dioxide).

Deco finish on request, not generally stocked.
Please always specify complete Renolit foil number with your inquiry.

Mounting guide for Buckling Angles

Glass or plastic surfaces: the glass or plastic must be clean, dry and free of any grease or fat. There must not even be the slightest film of moisture or grease. Clean with a dry cloth or rag.
Note: Do not use any cleaning agent containing surfactants (e.g. glass cleaner etc.).

Adhesive tape: the surface of adhesive tape must be also clean, dry and grease free. Therefore it is important to remove the protective foil carefully and only immediately before glueing.
Note: Initially the adhesive tape has only a minimal initial adhesion. Adhesive process takes 12-24 hours.

Working temperature:
On construction sites by lower temperatures there should be a hot-air fan available which can be used for warming up.
End butt joints are to be used to compensate any expansion of sections/ strips (summer/ winter).
A strong contact pressure will ensure a good, even surface contact. Press-down rollers are ideal tool for this.

Angles
TOP